Launch Control

Discussion in 'COBB Tuning' started by WScottCross, Apr 5, 2014.

  1. graynicolas11

    graynicolas11 Active Member

    I just wanna make sure I even did this you load a map onto ATR (for example, im using the stage 1, 91 octane map) so I load that then immediately just resave it as something else (for example stage 1, 91 octane LC) and then its on there? or does it have to applied somehow?
  2. Register or Sign in

    Advertisement Sponsor

  3. RodMoe

    RodMoe Well-Known Member

    Have you set the LC rpm in the launch control with the ATR ? Then once that's done save as you like with whatever name you want and then load it to the AP then flash your car ;)
    That is for a Hard rpm LC ( never need touch anything it's always on with car below mph/kph set point)
    Otherwise any new v103 map should have soft rev limiter with Cruise Control button control at 4000 rpm. With the latest firmware of course ..
  4. graynicolas11

    graynicolas11 Active Member

    just realized I was using the V102 feel like such a fool. Gonna upload the V103 map now and see if it works haha

Share This Page